LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1344 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Replacement - Liftgate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear wiper arm. Refer to Wiper Arm Replacement - Rear .
  2. Remove the nut (1) and the wiper packing (2).
  3. Open the liftgate glass (8).
    Fig 1: Liftgate Wiper Motor Components
    GM821861Courtesy of GENERAL MOTORS CORP.
  4. Remove the wiper motor cover (7) using a flat bladed tool.
  5. Disconnect the 2 rear defogger electrical connectors (3).
  6. Remove the 2 nuts (6) from the wiper motor assembly (5).
  7. Remove the rear wiper motor (5) from the liftgate glass (8).
  8. Disconnect the junction switch electrical connector (6).
  9. Remove the junction switch nut (4) and the junction switch (5).
  10. Remove the 3 screws (3) that hold the rear wiper shaft cover (1) to the wiper motor assembly (2).
  11. Remove the rear wiper shaft cover (1) from the wiper motor assembly (2).
    Fig 2: Separating Rear Wiper Shaft Cover From The Wiper Motor Assembly
    GM821863Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals