Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Plastic Nut Cover, Wiper Arm And Nut

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the windshield wiper arm (3) to the windshield wiper transmission. Secure the arm with the nut (2).
Tighten: Tighten the windshield wiper arm nut to 20.5 N.m (15 lb ft).
Install the plastic nut cover (1) to the wiper arm (3).