LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1344 (Wiper System & Washer System) >> Repair Instructions >> Wiper Arm Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Rear Wiper Arm Cap
    GM815863Courtesy of GENERAL MOTORS CORP.
  1. Install the rear wiper blade onto the rear wiper arm. Refer to Wiper Arm Blade Replacement - Rear .
  2. Align the rear wiper blade with the mark on the rear window.
  3. Install the rear wiper arm onto the rear wiper motor spindle.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the rear wiper arm nut.

    Tighten:  Tighten the nut to 5.5 N.m (4.0 lb ft).

  5. Install the cap to the rear wiper arm.
  6. Remove the mark from the rear window.
scientia non olet · About LEMON Manuals