LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1344 (Wiper System & Washer System) >> Repair Instructions >> Washer Solvent Container Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Washer Pumps, Washer Solvent Container And Washer Pump Hoses
    GM827645Courtesy of GENERAL MOTORS CORP.
  1. Install the windshield washer pumps (1) to the windshield washer solvent container (2).
  2. Install the windshield washer solvent container (2) by inserting the neck through the holes until tabs click.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 3 bolts to the windshield washer solvent container (2).

    Tighten:  Tighten the washer solvent container bolts to 5.5 N.m (49 lb in).

  4. Connect the washer hoses (4) to the washer pumps (3).
  5. Connect the washer pump electrical connectors (1).
  6. Reposition the right lower wheel house panel, and install the screws.

    Tighten:  Tighten the right lower wheel house panel screws to 10 N.m (89 lb in).

  7. Fill the washer solvent container (2) with washer solvent.
scientia non olet · About LEMON Manuals