LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1344 (Wiper System & Washer System) >> Repair Instructions >> Hose Replacement - Rear Window - Washer Pump to Endgate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Front End.
  2. Remove the right hinge pillar trim panel. Refer to Trim Replacement - Hinge Pillar in Interior Trim.
  3. Remove the right lower center pillar molding. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  4. Remove the right rear upper quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper in Interior Trim.
  5. Remove the rear dome lamp. Refer to Dome Lamp Replacement in Lighting Systems.
    6. Fig 1: Headliner And Retainers
    GM853427Courtesy of GENERAL MOTORS CORP.
  6. Remove the 2 push in retainers (2) from the rear of the headliner (1).
    7. Fig 2: Washer Pump To Endgate Components
    GM858516Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the rear washer hose (9) from the rear washer pump.
  8. Remove the rear washer hose end (9) out through the rubber conduit opening (12) under the right side of the instrument panel.
  9. Pull the rear edge of the headliner down to gain access to the rear washer hose (9).
  10. Disconnect the rear washer hose (9) from the washer nozzle hose (4).
  11. Remove the rear washer hose (9) from inside of the rear roof panel.
  12. Remove the rear washer hose (9) from the vehicle.
scientia non olet · About LEMON Manuals