LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1344 (Wiper System & Washer System) >> Repair Instructions >> Hose Replacement (Hose Connector to Washer Nozzle) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3 lower plastic retainers that retain the hood insulator.
  2. Fold back the bottom of the hood insulator in order to gain access to the windshield washer nozzle hose.
    3. Fig 1: Hose Connector Components
    GM858809Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the washer hose (3) from the following components:
    • The washer nozzle (4)
    • The hose connector (2)
  4. Position the hose connector higher than washer solvent container, if necessary in order to prevent the washer fluid from being lost.
  5. Remove the washer hose (3) from the vehicle.
scientia non olet · About LEMON Manuals