Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the right front wheelhouse panel liner. Refer to Wheelhouse Panel Replacement in Body Front End.
- Remove the 3 lower retainers from the hood insulator.
- Fold back the hood insulator.
- Disconnect the washer hose (1) from the Y-shaped hose connector (2).
- Perform one of the following actions in order to prevent the washer fluid from being lost:
- Plug the open of the hose connector
- Position the hose connector higher than washer solvent container
- Drain the washer solvent
- Disconnect the washer hose (1) from the washer pump.
- Remove the washer hose (1) from the vehicle.