Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Bumper Impact Bar Components

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 rear bumper stays (4) and the push-in retainers (3) to the impact bar (1), if removed.
Install the rear bumper impact bar (1) to the vehicle. Secure the impact bar with 4 nuts (2).

Tighten: Tighten the rear bumper impact bar nuts to 36 N.m (26 lb ft).
Install the rear bumper fascia energy absorber. Refer to Energy Absorber Replacement - Rear .
Install the rear bumper fascia. Refer to Fascia Replacement - Rear Bumper .