LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1343 (Bumper System) >> Repair Instructions >> Impact Bar Replacement - Front Bumper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Impact Bar And Nuts
    GM821141Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the front bumper impact bar (1) to the front bumper impact bar outer brackets. Secure the impact bar with the 4 nuts (2).

    Tighten:  Tighten the front bumper impact bar nuts to 36 N.m (26 lb ft).

  2. Install the front bumper fascia energy absorber from the front bumper impact bar.
  3. Install the front bumper fascia. Refer to Fascia Replacement - Front Bumper  .
scientia non olet · About LEMON Manuals