LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1343 (Bumper System) >> Repair Instructions >> Fascia Replacement - Rear Bumper >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear bumper fascia extension, if equipped. Refer to Fascia Extension Replacement - Rear  .
    2. Fig 1: Rear Bumper Fascia Components
    GM821553Courtesy of GENERAL MOTORS CORP.
  2. Open the lift gate.
  3. Remove the rear door sill plate. Refer to Door Sill Plate Replacement - Liftgate in Interior Trim.
  4. Remove the 4 rear bumper fascia nuts (1) from the rear sill.
  5. Remove the 4 push-in retainers (3) from the rear bumper fascia (5), using the J 38778.
  6. Remove the 2 screws (2) from the top right and left upper fascia.
  7. Remove the 2 screws (5) and retainers (4) from the right and left upper fascia.
  8. Disconnect the backup lamp electrical connectors. Refer to Backup Lamp Replacement in Lighting Systems.
  9. Remove the rear bumper fascia (6) from the vehicle.
  10. Remove the backup lamps from the vehicle, if required. Refer to Backup Lamp Replacement in Lighting Systems.
scientia non olet · About LEMON Manuals