Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Fascia Extension, Screws And Spacers

Courtesy of GENERAL MOTORS CORP.

Remove the screws (3) and spacers (1) from the left and right sides of the rear bumper fascia extension (2).

Fig 2: Rear Fascia Extension Screws And Washers

Courtesy of GENERAL MOTORS CORP.

Remove the lower screws and washers from the rear bumper fascia extension.
Remove the rear bumper fascia extension and two way tape. Refer to Molding/Nameplate Replacement - Exterior Trim in Exterior Trim.

Fig 3: Rear Fascia Extension Components

Courtesy of GENERAL MOTORS CORP.

Remove the rear bumper fascia extension screws (5), washers (4) and brackets (3) from rear fascia, if necessary.
Remove the Remove the U-clips (2) from the rear fascia (1), if necessary.

Fig 4: Rear Fascia Extension Components

Courtesy of GENERAL MOTORS CORP.

Remove the nuts (2), bolts (5), washers (3) and brackets (4) from the rear fascia (1), if necessary.

Fig 5: Rear Fascia Extension U-clips

Courtesy of GENERAL MOTORS CORP.

Remove the U-clips from the left and right sides of the rear fascia, if necessary.