Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Install the front bumper fascia extension brackets, if removed.
Install two way tape to the front bumper fascia extension. Refer to Molding/Nameplate Replacement - Exterior Trim in Exterior Trim.
Peel back 25.0 mm of the tape liner from both ends.
Align front bumper fascia extension to the brackets.

Fig 1: Removing/Installing Fascia Extension Components

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws (5) and the washers (4) to the brackets (6).
Tighten: Tighten the screws to 5 N.m (44 lb in).
Install the nuts (1) to the set screws (2).
Tighten: Tighten the nuts to 5 N.m (44 lb in).

Fig 2: Front Bumper Fascia Extension And Screw

Courtesy of GENERAL MOTORS CORP.

Install the screw (2) to the front bumper fascia extension (1).
Tighten: Tighten the screw to 2.5 N.m (22 lb in).

Fig 3: Fascia Extension Components

Courtesy of GENERAL MOTORS CORP.

Install the bracket (5) to the front bumper fascia extension (2).
Install the screw (3) and washer (4) to the bracket (5).
Tighten: Tighten the screw to 5 N.m (44 lb in).
Install the push in retainer (1).
Remove the tape liner from the rear of the front fascia extension and press down working from the rear to get good adhesion.
Lower vehicle.