Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the area where the molding, the emblem or the nameplate is to be mounted.
- Use a suitable solvent, such as a mixture of 50 percent isopropyl alcohol and 50 percent water, or equivalent.
- Dry the area thoroughly.
- Install adhesive tape (1) to the outside edges of the molding, the emblem or the nameplate.
- Ensure that the body area is at a temperature range of 20-30°C (68-86°F). Heat the area, if necessary.
- Ensure that the molding, the emblem or the nameplate are at a temperature range of 20-30°C (68-86°F). Heat the molding, if necessary.
- Remove the adhesive tape release sheet.
- Apply the molding, the emblem or the nameplate to the body surface.
- Apply an equal amount of pressure along the molding, the emblem or the nameplate to uniformly bond the molding or the emblem to the body surface.
IMPORTANT:
Apply the adhesive tape in an environment free of dust or dirt so that it does not come in contact with the sticky backing and prevent proper adhesion.