LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1342 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (Production Molding) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rocker Panel And Plastic clips
    GM815867Courtesy of GENERAL MOTORS CORP.
  1. Remove the plastic push-in retainers from the bottom of the rocker panel molding.
  2. Disengage the plastic clips to remove the rocker panel molding.
  3. Remove the rocker panel molding.
  4. Remove the plastic clips from the rocker panel molding.
scientia non olet · About LEMON Manuals