LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1342 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (Accessory Molding) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Plastic Push-In Retainer
    GM1230496Courtesy of GENERAL MOTORS CORP.
  1. Remove the plastic push-in retainer from the front of the rocker panel accessory molding.
    2. Fig 2: Rocker Panel Screw
    GM1230498Courtesy of GENERAL MOTORS CORP.
  2. Remove the screw from the rear of the rocker panel accessory molding.
  3. Remove the lower push-in retainers from the bottom of the rocker panel accessory molding.
  4. Remove the rocker panel accessory molding and the two way adhesive tape. Refer to Molding/Nameplate Replacement - Exterior Trim  in Exterior Trim.
scientia non olet · About LEMON Manuals