LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1342 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (Accessory Molding) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply two way adhesive tape to the rocker panel accessory molding. Refer to Molding/Nameplate Replacement - Exterior Trim  in Exterior Trim.
  2. Peel back 25 mm (1 in) of the two way tape liner from each end.
  3. Install rocker panel accessory molding to vehicle and fasten with the lower push-in retainers.
  4. Remove the two way tape liner, starting from the rear of the vehicle and press down working from the rear to get good adhesion.
    5. Fig 1: Rocker Panel Screw
    GM1230498Courtesy of GENERAL MOTORS CORP.
  5. Install the screw to the rear of the rocker panel accessory molding.
    6. Fig 2: Plastic Push-In Retainer
    GM1230496Courtesy of GENERAL MOTORS CORP.
  6. Install the plastic push-in retainer to the front of the rocker panel accessory molding.
scientia non olet · About LEMON Manuals