LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1342 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rear Door Body Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Protective Tape And Molding
    GM829268Courtesy of GENERAL MOTORS CORP.
  1. Apply protective tape (2) around the molding (3).
  2. Heat the molding using the J 25070  . See Special Tools and Equipment  . Apply heat using a circular motion for about 30 seconds.
    3. NOTE: Refer to Exterior Trim Emblem Removal Notice in Cautions and Notices.
  3. Remove the molding (3) from the door using a plastic flat-bladed tool.
  4. Wash the area with soapy water and wipe dry.
  5. Remove all traces of adhesive from the door using a oil-free naptha or alcohol.
scientia non olet · About LEMON Manuals