LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1341 (Body Front End) >> Repair Instructions >> Wheelhouse Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: Body Panel
    GM431898Courtesy of GENERAL MOTORS CORP.
  2. Remove fender flare. Refer to Flare Replacement - Front Fender in Body Front End.
  3. Remove the bolts and plastic retainers from wheel house panel.
  4. Remove the rocker panel molding. Refer to Molding Replacement - Rocker Panel (Production Molding)Molding Replacement - Rocker Panel (Accessory Molding) in Exterior Trim.
  5. Disengage the plastic retainers from the wheel house panel.
  6. Remove the wheel house panel (1) from the fender.
scientia non olet · About LEMON Manuals