LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1341 (Body Front End) >> Repair Instructions >> Wheelhouse Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Body Panel
    GM431898Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel house panel (1) to the fender.
  2. Secure the wheel house panel (1) with the bolts and the plastic retainers.

    Tighten:  Tighten the wheelhouse panel bolts to 10 N.m (89 lb in).

  3. Install the rocker panel molding. Refer to Molding Replacement - Rocker Panel (Production Molding)Molding Replacement - Rocker Panel (Accessory Molding) in Exterior Trim.
  4. Install the fender flare. Refer to Flare Replacement - Front Fender in Body Front End.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals