LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1341 (Body Front End) >> Repair Instructions >> Support Replacement - Center >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Air Temperature Sensor And Center Support Connector
    GM431893Courtesy of GENERAL MOTORS CORP.
  1. Remove the hood secondary catch and primary latch. Refer to Hood Latch Replacement  .
  2. Remove the input air temperature sensor (2) connector from the center support (1).
  3. Remove the upper fascia plastic retainer from the top of the center support.
    4. Fig 2: Hood Latch Components
    GM239366Courtesy of GENERAL MOTORS CORP.
  4. Remove the following components from the vehicle:
    • The 2 bolts
    • The center support (2)
scientia non olet · About LEMON Manuals