LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1341 (Body Front End) >> Repair Instructions >> Splash Shield Replacement - Engine - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Splash Shield, Bolts And Retainers
    GM850064Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the engine splash shield (3) to the vehicle. Secure the splash shield with the 2 bolts (1) and the 5 retainers (2).

    Tighten:  Tighten the engine splash shield bolts to 10 N.m (89 lb in).

  2. Lower the vehicle.
scientia non olet · About LEMON Manuals