LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1341 (Body Front End) >> Repair Instructions >> Hood Hinge Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Remove/Install Hood Hinge
    GM239365Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: When replacing the hood hinge, apply anti-corrosion treatment to the hinge and the body mating surface, and to the hinge and the hood mating surface. Refer to Anti-Corrosion Treatment and Repair in Paint/Coatings.
  1. Install the hood hinge (1) to the vehicle, aligning the mating marks. Secure the hinge with the 2 mounting bolts.

    Tighten:  Tighten the hinge bolts to 20 N.m (15 lb ft).

  2. Install the left front fender, if removed. Refer to Fender Replacement - Front - Left  .
  3. Install the right front fender, if removed. Refer to Fender Replacement - Front - Right  .
  4. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement  .
  5. Install the hood. Refer to Hood Replacement  .
scientia non olet · About LEMON Manuals