Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Install the front fender (1) to the vehicle. Secure the fender with the 1 bolt (2).
Tighten: Tighten the front fender bolt to 20 N.m (15 lb ft).
- Install the top 2 front fender (1) bolts.
Tighten: Tighten the top front fender bolts to 20 N.m (15 lb ft).
- Install the 2 door jamb (3) to front fender bolts.
Tighten: Tighten the door jamb to front fender bolts to 20 N.m (15 lb ft).
- Install the front fender (1) to rocker panel bolt.
Tighten: Tighten the front fender to rocker panel bolt to 20 N.m (15 lb ft).
- Install left fender rear inner splash guard.
- Install the left headlamp assembly. Refer to Headlamp Assembly or Headlamp Bulb Replacement in Lighting Systems.
- Install the front bumper fascia. Refer to Fascia Replacement - Front Bumper in Bumpers.
- Install the left rocker panel molding. Refer to Molding Replacement - Rocker Panel (Production Molding)Molding Replacement - Rocker Panel (Accessory Molding) .
- Install the left wheel house panel. Refer to Wheelhouse Panel Replacement .
- Install the left fender flare. Refer to Flare Replacement - Front Fender .
- Close hood panel.
NOTE:
Refer to Fastener Notice in Cautions and Notices.