Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
- Open the lift gate.
- Remove the lift gate trim panel. Refer to Trim Panel Replacement - Liftgate .
- Remove the high mounted stop lamp. Refer to High Mounted Stop Lamp Replacement in Lighting Systems.
- Disconnect the license plate lamp electrical connectors.
- Disconnect the lift gate latch electrical connectors.
- Disconnect the wiper motor electrical connectors.
- Disconnect the rear wiper relay connector.
- Disconnect the lower and upper harness connectors (1), (2).
- Release the wiring harness retainers from the lift gate.
- Remove the lower wiring harness from the lift gate.
- Disconnect upper harness boot (2) from lift gate (1)
- Remove upper harness from lift gate (1).
- Remove the left upper quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper in Interior Trim.
- Disconnect the upper lift gate harness connectors (1) from the rear body harness connectors (2)
- Disconnect the upper liftgate harness retainers (2) from the left inner quarter panel.
- Pull down on left rear of headliner to access harness for removal.
- Pull up on harness boot (2) and remove harness from rear upper body (3).