LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1338 (Body Rear End) >> Repair Instructions >> Strut Replacement - Liftgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Lower End Assist Rods
    GM621881Courtesy of GENERAL MOTORS CORP.
  1. Position the assist rods to the liftgate.
  2. Install the upper end of the assist rods to the ball joint. Press in to place until fully seated.
    3. Fig 2: Removing/Installing Upper End Assist Rods
    GM621880Courtesy of GENERAL MOTORS CORP.
  3. Install the lower end of the assist rods to the ball joint. Press in to place until fully seated.
  4. Remove the support from the liftgate.
  5. Close the liftgate.
scientia non olet · About LEMON Manuals