LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1338 (Body Rear End) >> Repair Instructions >> Strut Replacement - Liftgate Window >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
    Fig 1: Removing Liftgate Strut
    GM621882Courtesy of GENERAL MOTORS CORP.
  1. Open and support the liftgate window.
  2. Lift up the retainer clips on the assist rods using a small flat-bladed tool.
    3. Fig 2: Removing/Installing Upper End Assist Rods
    GM621880Courtesy of GENERAL MOTORS CORP.
  3. Remove the upper end of the assist rods from the ball joint.
    4. Fig 3: Removing/Installing Lower End Assist Rods
    GM621881Courtesy of GENERAL MOTORS CORP.
  4. Remove the lower end of the assist rods from the ball joint.
  5. Remove the assist rods from the liftgate window.
scientia non olet · About LEMON Manuals