LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1338 (Body Rear End) >> Repair Instructions >> Pressure Relief Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Bumper Fascia
    GM241439Courtesy of GENERAL MOTORS CORP.
  1. Install the quarter outer panel pressure relief valve (1). Ensure that the retaining tabs are fully engaged.
  2. Install the rear bumper fascia. Refer to Fascia Replacement - Rear Bumper in Bumpers.
scientia non olet · About LEMON Manuals