LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1338 (Body Rear End) >> Repair Instructions >> Lock Cylinder Replacement - Liftgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lock Cylinder Rod And Nuts
    GM824373Courtesy of GENERAL MOTORS CORP.
  1. Install the endgate lock cylinder (2) to the liftgate.
  2. Install the 2 nuts (3) to the lock cylinder (2).
  3. Connect the 2 rods (1) to the lock cylinder (2).
  4. Install the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate  .
  5. Close the liftgate.
scientia non olet · About LEMON Manuals