LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1338 (Body Rear End) >> Repair Instructions >> Latch Replacement - Liftgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Liftgate Latch Components
    GM824712Courtesy of GENERAL MOTORS CORP.
  1. Install the liftgate latch (3) to the liftgate.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts (4) to the liftgate latch (3).

    Tighten:  Tighten the liftgate latch bolts (4) to 7 N.m (62 lb in).

  3. Connect the rod (2) to the lock cylinder. Refer to Lock Cylinder Replacement - Liftgate  .
  4. Connect the electrical connector (5) to the liftgate latch (3).
  5. Connect the latch cable (1).
  6. Install the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate  .
  7. Close the liftgate.
scientia non olet · About LEMON Manuals