LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1338 (Body Rear End) >> Repair Instructions >> Latch Replacement - Liftgate Window >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Liftgate Window Latch Bolts
    GM890766Courtesy of GENERAL MOTORS CORP.
  1. Connect the rod to the lift gate window latch.
  2. Install the lift gate window latch (1) to the lift gate (5).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolts (2) to the lift gate window latch (1).

    Tighten:  Tighten the lift gate window latch bolts (2) to 7.0 N.m (62 lb in).

  4. Install the rear lift gate window connector (4) to the lift gate (5).
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the bolts (3) to the lift gate window connector (4).

    Tighten:  Tighten the lift gate window connector bolts (3) to 7.0 N.m (62 lb in).

  6. Close the lift gate window.
    7. Fig 2: Liftgate Window Latch Components
    GM890760Courtesy of GENERAL MOTORS CORP.
  7. Open the lift gate.
  8. Install the lift gate window latch electrical connector retainer (3) to the lift gate (4).
  9. Connect the lift gate window latch electrical connector (2) to the lift gate harness (1).
  10. Install the lift gate trim panel. Refer to Trim Panel Replacement - Liftgate  .
  11. Close the lift gate.
scientia non olet · About LEMON Manuals