LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1338 (Body Rear End) >> Repair Instructions >> Fuel Filler Door Release Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Tank Filler Door Latch Release Cable And Retaining Clips
    GM879358Courtesy of GENERAL MOTORS CORP.
  1. Install and route the fuel tank filler door latch release cable (1) to the vehicle. Secure the cable to the retaining clips.
  2. Install the fuel tank filler door latch release cable (1) to the fuel tank filler door retainer (2) by turning clock wise.
  3. Install the left lower quarter panel trim. Refer to Trim Panel Replacement - Rear Quarter Lower in Interior Trim.
  4. Fig 2: Fuel Filler Door Release Cable Retainers
    GM328464Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the fuel tank filler door latch release cable to the fuel/rear compartment release handle housing (2). Secure the housing with the bolt.

    Tighten:  Tighten the handle housing bolt to 10 N.m (89 lb in).

  6. Reposition the floor panel carpet (3) to its original position.
  7. Install the floor carpet retainers (1) to the left front and rear door sill pinch flange.
  8. Install the left center pillar lower trim panel. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  9. Install the left front and rear side door sill trim plates. Refer to Door Sill Plate Replacement in Interior Trim.
  10. Install the body hinge pillar trim panel. Refer to Trim Replacement - Hinge Pillar in Interior Trim.
  11. Install the foot rest. Refer to Foot Rest Replacement in Interior Trim.
  12. Install the left front seat. Refer to Seat Replacement - Front Bucket in Seats.