LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1336 (Door System, Mirror System & Window System) >> Repair Instructions >> Trim Panel Replacement - Side Rear Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Trim Panel Components
    GM847858Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear side door inside handle. Refer to Door Handle Replacement - Rear Inside .
  2. Remove the screw (4) and trim cover (3) from the rear side door trim panel (1).
  3. Remove the screw (2) that retains the door trim panel (1).
    4. Fig 2: Removing Regulator Handle
    GM242337Courtesy of GENERAL MOTORS CORP.
  4. Remove the rear side door window regulator handle by using a cloth to pull off the snap ring, if equipped.
  5. Using a taped flat bladed tool, gently pry the rear side door window switch bezel from the rear side door trim, if equipped.
  6. Disconnect the rear side door window switch electrical connector, if equipped.
  7. Remove the rear side door window switch bezel from the vehicle, if equipped.
    8. Fig 3: Un-clipping/Clipping Rear Side Door Trim
    GM847865Courtesy of GENERAL MOTORS CORP.
  8. Unclip and remove the rear side door trim from the door by disengaging the 7 plastic retainers.
scientia non olet · About LEMON Manuals