LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1336 (Door System, Mirror System & Window System) >> Repair Instructions >> Trim Panel Replacement - Side Front Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Trim Panel Components
    GM847884Courtesy of GENERAL MOTORS CORP.
  1. Remove the screw (4) and trim cover (3) from the front side door trim panel (1).
  2. Remove the screw (2) that retains the front side door trim panel (1).
    3. Fig 2: Removing Regulator Handle
    GM242337Courtesy of GENERAL MOTORS CORP.
  3. Remove the front side door window regulator handle by using a cloth in order to pull off the snap ring, if equipped.
    4. Fig 3: Removing Trim Panel And Mounting Plate
    GM626673Courtesy of GENERAL MOTORS CORP.
  4. Using a taped flat bladed tool, gently pry the front side door accessory switch mounting plate (1) from the front side door trim (2), if equipped.
    5. Fig 4: Power Window Switch Electrical Connector
    GM626703Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the front side door window and/or lock switch electrical connectors (2, 3), if equipped.
  6. Remove the front side door accessory switch mounting plate (1) from the vehicle, if equipped.
    7. Fig 5: Side Door Inside Handle
    GM847889Courtesy of GENERAL MOTORS CORP.
  7. Remove the front side door inside handle. Refer to Door Handle Replacement - Front Inside .
  8. Remove the front side door trim from the door by disengaging the 8 plastic retainers.
scientia non olet · About LEMON Manuals