Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Door Handle Screws And Cover

Courtesy of GENERAL MOTORS CORP.

Remove the rear side door lock. Refer to Lock Replacement - Rear Door .
Remove the following components from the door:
- The torx screw (6)
- The outside door handle cover (1)

Fig 2: Outside Handle Frame

Courtesy of GENERAL MOTORS CORP.

Pull and hold the release plate of the outside handle frame.

Fig 3: Door Handle

Courtesy of GENERAL MOTORS CORP.

While holding release plate, push the outside handle toward the rear of the door and remove.

Fig 4: Door Handle Screws And Cover

Courtesy of GENERAL MOTORS CORP.

Loosen the torx screw (4) and remove the outside handle frame assembly (5), if necessary.
Remove handle gaskets (3) from door, if necessary.

Fig 5: Handle Frame Clip

Courtesy of GENERAL MOTORS CORP.

Remove handle clip (1) if necessary, by pressing the upper and lower.