LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (Seat System) >> Repair Instructions >> Seat Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the rear seat to the anchors.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Plastic Hinge Covers, Hinge Bolts, Lower Bolts And Rear Seat
    GM833610Courtesy of GENERAL MOTORS CORP.
  2. Install the lower seat bolts (3).

    Tighten:  Tighten the lower seat bolts (3) to 18 N.m (13 lb ft).

  3. Install center seat belt retractor, if removed. Refer to Seat Belt Retractor Replacement - Center Rear .
  4. Install the seat back hinge bolts (2).

    Tighten:  Tighten the seat back hinge bolts (2) to 18 N.m (13 lb ft).

  5. Install the plastic hinge covers (1).
  6. Install the rear seat to its original position.
scientia non olet · About LEMON Manuals