LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (Seat System) >> Repair Instructions >> Seat Cushion Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Cushion Components
    GM849882Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Slide the rear seat cushion into position. Ensure that the seat belt buckles are properly position through the cushion.
  2. Install the 2 lower mounting bolts (4)

    Tighten:  Tighten the lower mounting bolts (4) to (41 N.m and 30 lb ft).

  3. Install the 2 pivot bolts (2).

    Tighten:  Tighten the pivot bolts (2) to (18 N.m and 13 lb ft).

  4. Install the rear seat back trim panel. Refer to Trim Panel Replacement - Rear Seat Back (Left)  or Trim Panel Replacement - Rear Seat Back (Right) .
scientia non olet · About LEMON Manuals