LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (Seat System) >> Repair Instructions >> Seat Back Replacement - Rear Split Folding >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Plastic Hinge Covers, Hinge Bolts And Seat Back Cushion
    GM833481Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the rear seat back cushion (3) to the vehicle. Secure the rear seat back cushion with the 2 bolts (2).

    Tighten:  Tighten the seat back cushion bolts to 18 N.m (13 lb ft).

  2. Install the outer pivot support bolts to the rear seat back cushion (3).

    Tighten:  Tighten the outer pivot support bolts to 18 N.m (13 lb ft).

  3. Install the center rear seat belt retractor, if removed. Refer to Seat Belt Retractor Replacement - Center Rear .
  4. Install the rear seat back trim panel. Refer to Trim Panel Replacement - Rear Seat Back (Left)  or Trim Panel Replacement - Rear Seat Back (Right) .
  5. Install the 2 plastic hinge covers (1) to the back of the seat back cushion cover.
  6. Return the seat back to the upright position.
  7. Install headrest, if removed. Refer to Head Restraint Replacement - Rear Seat .
scientia non olet · About LEMON Manuals