LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat assembly. Refer to Seat Replacement - Front Bucket .
  2. Remove the front seat back assembly. Refer to Seat Back Replacement - Front (Driver Side)  or Seat Back Replacement - Front (Passenger Side) .
  3. Remove the head restraint (1) from the seat back cushion (3).
    Fig 1: Head Restraint, Restraint Guides And Seat Back Cushion
    GM431906Courtesy of GENERAL MOTORS CORP.
    4. Fig 2: Head Restraint Guides And Seat Back Cushion
    GM431907Courtesy of GENERAL MOTORS CORP.
  4. Gently pry the head restraint guides (1) from the seat back cushion (2) using a flat-bladed tool.
    5. Fig 3: Seat Back Cover Components
    GM863258Courtesy of GENERAL MOTORS CORP.
  5. Remove the seat back trim panel, if necessary. Refer to Seat Back Trim Replacement - Front .
  6. Cut and remove the hog rings.
  7. Roll the seat back cushion cover (1) upward slowly and evenly.
  8. Remove the seat back cushion pad (2) from the frame (3), if necessary.
scientia non olet · About LEMON Manuals