LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Back Cover Components
    GM863258Courtesy of GENERAL MOTORS CORP.
  1. Install the seat back cushion pad (2) to the frame (3), if removed.
  2. Roll the seat back cushion cover (1) down over the seat back cushion (2).
  3. Use hog ring pliers to install new hog rings. Ensure that the seat back cushion cover (1) is secure.
  4. Install seat back trim panel, if removed. Refer to Seat Back Trim Replacement - Front .
    5. Fig 2: Head Restraint, Restraint Guides And Seat Back Cushion
    GM431906Courtesy of GENERAL MOTORS CORP.
  5. Install the head restraint guides (2) to the seat back cushion (3).
  6. Install the head restraint (1) to the seat back cushion (3).
  7. Install the front seat back assembly. Refer to Seat Back Replacement - Front (Driver Side)  or Seat Back Replacement - Front (Passenger Side) .
  8. Install the front seat assembly. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals