LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad - Rear Split Folding >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Seat Back Release Latch Components
    GM849131Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear seat head restraint (1). Refer to Head Restraint Replacement - Rear Seat .
  2. Remove the rear seat back cushion. Refer to Seat Back Replacement - Rear Split Folding .
  3. Remove rear seat latch knob (11) and retainer (10).
    4. Fig 2: Cushion Cover
    GM241556Courtesy of GENERAL MOTORS CORP.
  4. Remove the plastic retainers which secure the seat back cushion cover (1) to the back of the seat.
    5. Fig 3: Rear Seat Cushion
    GM241636Courtesy of GENERAL MOTORS CORP.
  5. Cut and remove the hog rings around the perimeter of the back of the rear seat back cushion (1).
    6. Fig 4: Rear Seat Back Release Latch Components
    GM849131Courtesy of GENERAL MOTORS CORP.
  6. Remove the rear seat back cushion cover (6) from the cushion (5).
  7. Remove the seat back latch (8), if necessary. Refer to Seat Back Release Latch Replacement - Rear  in Seats.
  8. Remove the rear seat back cushion pad (5) from the frame (4), if necessary.
scientia non olet · About LEMON Manuals