LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad - Rear Split Folding >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Seat Back Release Latch Components
    GM849131Courtesy of GENERAL MOTORS CORP.
  1. Install the rear seat back cushion pad (5) to the frame (4), if removed.
  2. Install the rear seat back latch (8), if removed. Refer to Seat Back Release Latch Replacement - Rear  in Seats.
  3. Install the rear seat back cushion cover (6) to the seat back cushion (5).
  4. Install the seat latch retainer (10) and knob (11).
    5. Fig 2: Hog Ring Pliers And Rear Seat Cushion
    GM404793Courtesy of GENERAL MOTORS CORP.
  5. Use hog ring pliers (1) to install new hog rings. Ensure that the rear seat back cushion cover is secured to the cushion (2).
  6. Install the plastic retainers which secure the seat back cushion cover to the back of the seat.
    7. Fig 3: Rear Seat Back Release Latch Components
    GM849131Courtesy of GENERAL MOTORS CORP.
  7. Install the rear seat back cushion. Refer to Seat Back Replacement - Rear Split Folding .
  8. Install the rear seat head restraint (1). Refer to Head Restraint Replacement - Rear Seat .
scientia non olet · About LEMON Manuals