LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (Seat System) >> Repair Instructions >> Seat Back Center Pivot Replacement - Rear Folding >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Center Pivot Support And Bolts
    GM848941Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the rear seat back cushion center pivot support (1) to the vehicle. Secure the support with the 2 bolts (2).

    Tighten:  Tighten the center pivot support bolts to 18 N.m (13 lb in).

  2. Install the rear seat back cushion. Refer to Seat Back Replacement - Rear Split Folding .
scientia non olet · About LEMON Manuals