LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (Seat System) >> Repair Instructions >> Seat Adjuster Track Cover Replacement - Front (Outboard) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Outer Track Cover, Tabs And Screws
    GM845158Courtesy of GENERAL MOTORS CORP.
  1. Install the outboard adjuster finish cover (3) to the front seat assembly, by engaging the tabs (1).
  2. Install the 2 screws (2) to the outer track cover (3).
    3. Fig 2: Retaining Tab And Recliner Handle
    GM845154Courtesy of GENERAL MOTORS CORP.
  3. Install the recliner handle (2) to the front seat outboard adjuster.
  4. Make sure recliner handle tab (1) engages to the recliner.
  5. Enable driver seat SIR, if outer track cover is removed. Refer to SIR Disabling and Enabling Zone 7 in SIR.
  6. Enable passenger sear SIR, if outer track cover is removed. Refer to SIR Disabling and Enabling Zone 9 in SIR.
scientia non olet · About LEMON Manuals