LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1333 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Upper Center Pillar >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Seat Shoulder Belt Guide Adjuster And Seat Belt
    GM240007Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR System. Refer to SIR Disabling and Enabling Zones in SIR.
  2. Remove the front side door sill trim plate. Refer to Door Sill Plate Replacement  .
  3. Remove the rear door sill trim plate. Refer to Door Sill Plate Replacement  .
  4. Remove the center pillar lower trim panel. Refer to Trim Panel Replacement - Lower Center Pillar  .
  5. Remove the seat shoulder belt guide adjuster (1) trim cover and the bolt.
  6. Position the belt (2) on the floor.
    7. Fig 2: Upper Trim Panel And Tab
    GM853461Courtesy of GENERAL MOTORS CORP.
  7. Remove the center pillar upper trim panel (2) by gently pulling loose.
scientia non olet · About LEMON Manuals