LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1333 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Upper Center Pillar >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Trim Panel And Tab
    GM853461Courtesy of GENERAL MOTORS CORP.
  1. Install the center pillar upper trim panel (2), by pushing in until tab (1) fastens.
    2. Fig 2: Removing/Installing Seat Shoulder Belt Guide Adjuster And Seat Belt
    GM240007Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the seat shoulder belt guide adjuster (1) bolt.

    Tighten:  Tighten the adjuster bolt to 42 N.m (31 lb ft).

  3. Install the seat shoulder belt guide trim cover.
  4. Install the center pillar lower trim panel. Refer to Trim Panel Replacement - Lower Center Pillar  .
    5. Fig 3: Side Door Sill Trim Plate
    GM241645Courtesy of GENERAL MOTORS CORP.
  5. Install the front side door sill trim plate (1) to the vehicle. Refer to Door Sill Plate Replacement  .
  6. Install the rear side door sill trim plate. Refer to Door Sill Plate Replacement  .
  7. Enable the SIR System. Refer to SIR Disabling and Enabling Zones in SIR.
scientia non olet · About LEMON Manuals