LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1333 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Rear Quarter Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Trim Panel And Plastic Retainers
    GM854131Courtesy of GENERAL MOTORS CORP.
  1. Install the quarter upper trim panel (2) to the vehicle. Ensure that the plastic retainers are fully engaged.
  2. Install the quarter lower trim panel. Refer to Trim Panel Replacement - Rear Quarter Lower  .
    3. Fig 2: Seat Belt Shoulder Anchor, Cover And Bolts
    GM832164Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the seat belt shoulder anchor (7) to the vehicle and secure with shoulder anchor bolt (8).

    Tighten:  Tighten the seat belt shoulder anchor bolt to 41 N.m (30 lb ft)

  4. Close shoulder anchor cover (1).
scientia non olet · About LEMON Manuals