LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1333 (Interior Trim) >> Repair Instructions >> Headliner Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Frame Garnish Moldings
    GM432007Courtesy of GENERAL MOTORS CORP.
  1. Remove the center pillar upper trim panel. Refer to Trim Panel Replacement - Upper Center Pillar  .
  2. Lower the door opening frame garnish moldings (1, 2) on the front and rear door pinch weld flanges.
  3. Remove the assist handles. Refer to Assist Handle Replacement  .
    4. Fig 2: Windshield Side Garnish Molding
    GM241992Courtesy of GENERAL MOTORS CORP.
  4. Gently pry and remove the windshield side garnish moldings (1).
  5. Remove the sunshades and retainers. Refer to Sunshade Replacement  .
  6. Remove the courtesy and reading lamp/sunroof switch assembly, if equipped. Refer to Sunroof Switch Replacement in Roof.
  7. Remove the dome lamp. Refer to Dome Lamp Replacement in Lighting Systems.
  8. Remove the quarter upper trim panel. Refer to Trim Panel Replacement - Rear Quarter Upper  .
    9. Fig 3: Headlining Trim Finish Panel And Retainers
    GM853427Courtesy of GENERAL MOTORS CORP.
  9. Lower the front seat back cushions in order to gain clearance to remove the headlining trim finish panel.
  10. Remove the 2 retainers (2) which secure the rear of the headlining trim finish panel.
  11. Lower the headlining trim finish panel (1). Remove the headlining through a rear door.
scientia non olet · About LEMON Manuals