LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1333 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Body Side Lower Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Garnish Molding, Rear Seat Hinge And Bolts
    GM854615Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear seat assembly. Refer to Seat Replacement - Rear in Seats.
  2. Remove the bolt (2).
  3. Remove the rear seat hinge (3).
  4. Gently pry the rear body side lower garnish molding plastic retainers and remove the molding (1) from the vehicle.
scientia non olet · About LEMON Manuals