LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1333 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Body Side Lower Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Garnish Molding, Rear Seat Hinge And Bolts
    GM854615Courtesy of GENERAL MOTORS CORP.
  1. Install the rear body side lower garnish molding (1) to the vehicle. Ensure that the plastic retainers are fully seated.
  2. Install the rear seat hinge (3) to the rear body side lower garnish molding (1).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolt (2) to the rear seat hinge (3).

    Tighten:  Tighten the rear seat hinge bolt to 18 N.m (13 lb ft).

  4. Install the rear seat assembly. Refer to Seat Replacement - Rear in Seats.
scientia non olet · About LEMON Manuals