LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 133 (Supplemental Inflatable Restraint System) >> Diagnostic Tests >> DTC B1001: Option Configuration Error >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. If SIR diagnostic system check has been performed, go to next step. If SIR diagnostic system check has not been performed, go to SIR DIAGNOSTIC SYSTEM CHECK .
  2. Using scan tool, verify that PCM is programmed with correct VIN. If VIN is not correct, go to next step. If VIN is correct, go to step  4.
  3. Using scan tool, program correct VIN into PCM. Go to step  8.
  4. If BCM was not replaced, go to next step. If BCM was replaced, go to step  6.
  5. Using scan tool, verify BCM is programed with correct VIN. If VIN is correct, go to step  7. If VIN is not correct, go to next step.
  6. Using scan tool, follow instructions under BCM SPECIAL FUNCTIONS to program BCM. Go to step  8.
  7. Replace SDM. See SENSING & DIAGNOSTIC MODULE (SDM)  under REMOVAL & INSTALLATION. Go to next step.
  8. Reconnect all SIR components. Using scan tool, clear DTC's. Road test vehicle, then check for DTC's. If DTC's are retrieved, go to step  2. If no DTC's are retrieved, system is normal.
scientia non olet · About LEMON Manuals